Locker-down Model LD 2019 Manuel d'utilisateur télécharger pdf

Instructions for Model 2019 with USB extension

1. If you have a combination lock, it is easier to set the

combination before installing the safe.

2. Open console and remove rubber pad in the floor of console.

3. There are 4 screws holding down the console, remove all four.

4. Put the lid assembly in as shown in Fig 1, turn and pull up to top.

5. Put in right side plate sliding it under USB cable and attach nuts.

6. Put in left side plate and attach nuts.

7. Install and tighten the four longer screws to attach both side

plates to bottom and tighten the four nuts holding the top to the

side plates

Enjoy your purchase.

Top Assembly Right Side Plate Left Side Plate

1 2

Page 1

Instructions for Model 2019 with USB extension 1. If you have a combination lock, it is easier to set the combination before installing the safe. 2.

Page 2

Pas de commentaire

Locker-down Model LD 2019 Manuel d'utilisateur